Kit Contents
- 60 Micro Vortex Generators for wing installation (just aft of the leading edge)
- 24 Micro Vortex Generators for installation on the underside of the horizontal stabilizer
- Detailed installation drawings and instructions
- Precision VG placement templates
- Spare vortex generators
- Loctite® Depend™ adhesive
Construction & Finish
Micro Vortex Generators are manufactured from 6063-T6 aircraft-grade aluminum under FAA PMA approval. Each VG is alodined to Boeing mil-spec standards for corrosion resistance and durability, and supplied ready for paint. The curved base of each vortex generator is contoured to match the aircraft surface, ensuring proper fit, adhesion, and aerodynamic performance.
Optional paint matching to your aircraft’s finish is available at an additional cost.
How Micro Vortex Generators Work
Micro Vortex Generators are installed in a spanwise line approximately 10% aft of the wing’s leading edge. Each VG creates a small, controlled vortex that energizes the boundary layer of airflow over the wing’s upper surface. This energized airflow resists separation, allowing the wing to maintain lift and control at lower airspeeds and higher angles of attack. The result is improved performance, enhanced stability, and greater control authority—especially during critical low-speed and short-field operations.
