Kit Contents
- 80 Micro Vortex Generators for wing installation (aft of the leading edge)
- 32 Micro Vortex Generators for installation under the horizontal stabilizer
- Detailed installation drawings and instructions
- VG placement templates
- Spare vortex generators
- Loctite® Depend adhesive
Construction & Finish
Micro Vortex Generators are manufactured from 6063-T6 aircraft-grade aluminum under FAA PMA approval. Each VG is alodined to Boeing mil-spec standards and supplied ready for paint. The curved base matches the wing contour for proper installation and performance.
Optional painting to match your aircraft is available at an additional cost.
How Micro Vortex Generators Work
Micro Vortex Generators create small, controlled vortices that energize the boundary layer of air over the wing. This energized airflow resists separation, allowing the wing to maintain lift and control at lower airspeeds and higher angles of attack. VGs are installed in a spanwise line approximately 10% aft of the wing’s leading edge to maximize effectiveness.