Single engine preheating is accomplished through electrical resistance heat in the form of thin pads sized and shaped to fit various parts. The pads are surface mounted with a bonding adhesive. This includes engine accessory and reduction gearboxes, fluids, and attached accessories. Power is routed to the heat elements through a dedicated wiring assembly with power indication and circuit overload protection. System is self-regulating through design. Heated components reach an average state of thermal equilibrium in approximately six hours.

This single engine preheat kit when installed will supply 635 watts with a 5.5 amp draw at 115 volts.
This single engine preheat kit when installed will supply 635 watts with a 2.8 amp draw at 230 volts.

This kit does not include ground power connection. Purchased separately.

* AVF0001 form requested for verification of purchase.

Applicable on DHC 7 aircraft and others.

For the following engines:

PT6A-50,