Kit Contents
- 68 Micro Vortex Generators for wing installation (just aft of the leading edge and aft of the slot)
- 32 Micro Vortex Generators for installation on the underside of the horizontal stabilizer
- Detailed drawings and step-by-step installation instructions
- VG placement templates
- Spare vortex generators
- Loctite® Depend™ adhesive
Construction & Finish
Micro Vortex Generators are manufactured under FAA PMA from 6063-T6 aircraft-grade aluminum, alodined to Boeing mil-spec standards, and supplied ready for paint. Each VG is curved to match the contour of the wing for proper fit and performance.
Optional painting to match your aircraft is available at an additional cost.
How Micro Vortex Generators Work
A Micro Vortex Generator creates a small, controlled vortex over the airfoil, energizing the normally stagnant boundary layer of air on the wing surface. This energized airflow resists separation, allowing the wing to remain effective at lower airspeeds and higher angles of attack. VGs are installed in a spanwise line approximately 10% aft of the wing’s leading edge, where they control airflow over the upper surface of the wing to improve performance and control authority.