Kit Contents
- 88 Micro Vortex Generators installed full span on the wings (just aft of the leading edge)
- 38 Micro Vortex Generators mounted on the vertical stabilizer
- 48 Micro Vortex Generators mounted under the horizontal stabilizer
- FAA STC documentation
- Detailed installation drawings and instructions
- VG positioning templates
- Spare vortex generators
- Loctite® Depend™ adhesive
Construction & Finish
Micro Vortex Generators are manufactured under FAA PMA approval from 6063-T6 aircraft-grade aluminum. Each VG is alodined to Boeing mil-spec standards for corrosion resistance and long-term durability. The contoured base of each VG is designed to precisely match the aircraft surface, ensuring proper fit, adhesion, and aerodynamic performance. All units are supplied ready for paint.
Optional paint matching to your aircraft is available at an additional cost.
How Micro Vortex Generators Work
Micro Vortex Generators create small, controlled vortices that energize the boundary layer of airflow over the wing and tail surfaces. This energized airflow resists separation, allowing the wing to maintain lift and control at lower airspeeds and higher angles of attack. The result is improved low-speed performance, better control authority, and increased safety throughout takeoff, approach, and landing.
