Tanis Heli-Preheat Kit - Lycoming (R22)

Heli-Preheat Kit – Robinson R22

Preheat is applied through electrical resistance heat elements located in each cylinder assembly, on engine crankcase and oil sump/tank, main and tail rotor gearboxes, and hydraulic reservoir, preheat critical components, oil, and attached accessories. Power is routed to the elements through a dedicated wiring assembly with circuit overload protection and power indicator light. System is self-regulating through design. Heated components reach an average state of thermal equilibrium in approximately six hours.

This preheat kit when installed will supply 349 watts with a 3.0 amp draw at 115 volts.
This preheat kit when installed will supply 349 watts with a 1.5 amp draw at 230 volts.

* Required Bonding sealant sold separately. Quantity 1, PN: TU02788

* AVF0001 form requested for verification of purchase.