Kit Contents
- 92 Micro Vortex Generators for full-span wing installation (just aft of the leading edge)
- 58 Micro Vortex Generators for installation near the leading edge of the flaps
- Detailed installation drawings and instructions
- Precision VG placement templates
- Spare vortex generators
- Loctite® Depend™ adhesive
Construction & Finish
Micro Vortex Generators are manufactured from 6063-T6 aircraft-grade aluminum under FAA PMA approval. Each VG is alodined to Boeing mil-spec standards for corrosion resistance and durability, and supplied ready for paint. The curved base of each vortex generator is contoured to match the aircraft surface, ensuring proper fit, adhesion, and aerodynamic performance.
Optional paint matching to your aircraft’s finish is available at an additional cost.
How Micro Vortex Generators Work
Micro Vortex Generators are installed in a spanwise line approximately 10% aft of the wing’s leading edge, with additional units positioned near the leading edge of the flaps. Each VG creates a small, controlled vortex that energizes the boundary layer of airflow over the wing and flap surfaces. This energized airflow resists separation, allowing the wing to maintain lift and control at lower airspeeds and higher angles of attack. The result is improved performance, enhanced stability, and safer, more confident operations—especially during water takeoffs and low-speed flight.
