Home > Probes, Sensors, Adaptors, P-Leads > JPI Probes and Sensors >

JP Instruments OAT Probe with shield and extension lead
JP Instruments OAT Probe with shield and extension lead
JP Instruments OAT Probe with shield and extension lead


 

The Outside Air Temperature (OAT) probe has an outside aluminum shield which is used to both hold the probe in place and shield it from radiated heat. When installing the OAT probe, shield the sensor from direct sunlight and engine heat. The OAT probe is installed in the airframe manufactures recommended location, if this information is not available, we recommend installing the probe in clean airflow such as in a cabin air scoop or below the underside of the wing away from engine heat or exhaust heat.

  • 1 Thermocouple Type K OAT Probe
  • 1-10 Ft. Option Wire
Sale Price: $162.00

Product Code: OAT-PROBE-WITH-SHIELD
Qty:

Features Technical Specs
 
Features
Install the OAT probe in the airframe manufacturer�s recommended location. If this information is not available, place out on the underside of the wing. Make sure probe is away from engine heat or exhaust. In this case it is recommended that the installation be done similar to the antenna installation instructions of AC 43.13-2A �Acceptable Methods, Techniques and Practices.� ** DO NOT USE COPPER WIRE.**

Share your knowledge of this product. Be the first to write a review »