BatteryMINDer 24V - 4A CEC2 Charger/Maintainer for Gill Batteries, Battery Minder 244CEC2-AA-S2, Aircraft Battery Minder, Aircraft storage, Emapa

Home > BatteryMINDer >

BatteryMINDer 24V - 4A CEC2 Charger/Maintainer for Gill Batteries

Alternative Views:

BatteryMINDer® Model 244CEC2-AA-S2: 24-Volt 4 AMP GILL® Aviation Battery Charger-Maintainer-Desulfator

These chargers-maintainers-desulfators are designed for all size and type 24-Volt GILL® Aviation Aviation Batteries. If you want the longest possible life and performance from your batteries there is no other product better at doing just this and BatteryMINDer® Guarantees it!

NONE OF OUR AIRCRAFT MODELS ARE DESIGNED TO FUNCTION AT INPUT VOLTAGES ABOVE 120 VAC EXCEPT WHEN COMBINED WITH AN ISOLATION STEP-DOWN TRANSFORMER.

Guaranteed to never overcharge/undercharge. (33°F to 130°F)
Tested and endorsed by leading Battery makers.
100% Full - Time U.S. Patented Pulse-type Desulfation keeps battery free of sulfate or dissolves sulfate completely in older batteries.
Detects and rejects batteries with bad cells. Terminate charge to prevent out-gassing.
Maximize battery life and capacity, recovers weak batteries.
Diagnoses battery’s condition / state-of-charge.
Recovers weak or deeply discharged batteries: including but not limited to flooded filler cap, maintenance-free, valve regulated lead-acid (VRLA), sealed lead-acid (SLA), starter, deep cycle and hybrid.
Maintain up to 2 batteries at a time. (requires BatteryMINDer® Y-Connector Accessory 210-AY)
Auto-Restart after power failure.
Intrusion protected from water and dust per IEC STANDARD IP65.
Bad cell detection with auto-shutdown.
Includes Short circuit, spark, reverse polarity protection, thermal runaway protection, automatic D/C disconnect on A/C failure and quick-connect/disconnect fused alligator clip assembly.
Very high efficiency. California CEC Approved. Certified to California Energy Commission Standards.
Automatically detects input AC power.
ECO-mode with hi-efficiency / low power consumption. This allows the unit to always remain connected to AC while consuming very low level of electricity.
Ambient temperature compensation. Built-in temperature sensor automatically adjusts charge rate to ensure full-charge. (as low as 0°F or as high as 130°F)
12 LED indicators show state-of-charge and important status mode / battery condition.
Rugged, vibration-resistant construction.
Never connect two or more batteries together before fully charging each and checking their condition. Failure to fully charge each battery and check their condition can result in a serious safety hazard.