Home > Lights >

AeroLEDs Certified Sun Tail Navigation Lights PN 11-1060
AeroLEDs Certified Sun Tail Navigation Lights
AeroLEDs Certified Sun Tail Navigation Lights


 
AERO LEDs:
Long Life:
LEDs easily last over 50,000 hours of continuous operation. Unlike most other light sources, LEDs do not have their lifespan reduced by on/off cycles.
High Efficiency: The LEDs used in AeroLEDs products have high lumen efficacy ratings, and as a result our products typically use less than 1/3 the power of halogen bulbs.
Shock and Vibration Resistant: The LEDs in our product are solid-state mounted devices that can tolerate high levels of shock and vibration without failing.
Built in Pulse Mode and Synchronization: All landing light products have a built-in pulse mode that blinks the light on and off at a 1Hz rate when power is applied to the pulse mode power wire. All landing light products synchronize with each other regardless of model to create a wig-wag alternating flashing pattern for enhanced in flight visibility for air to air and air to ground collision avoidance and recognition.

SUNTAIL
Product Number: 11-1060 TSO Certified
Power: 20 Watts
Voltage: 9-36 VDC
Lumens: Exceeds TSO candela requirements
Weight: 3 oz
Dimensions: 1.7" x 2.15" x 2.61"

Sale Price: $495.00

Product Code: AEROLEDS-CERT-SUN-TAIL-NAV

Special Instructions



Qty:  
Features Technical Specs Information
 
Features
What is the difference between the Pulsar NS and the Pulsar NSP?
The Pulsar NS has a forward red or green navigation light, and a strobe that covers 180 degrees from each wing tip.
The Pulsar NSP has a forward red or green navigation light, a strobe that covers 180 degrees from each wing tip, and a rear white position light.
What are the installation requirements for the Sunspot 36?
The Sunspot 36LX landing and taxi lights can be installed with just a log book entry if you can install the light in an existing mount and use the existing wires, switches, and circuit breakers.
The Sunspot 36HX landing and taxi lights can be installed with the pulse function enabled in a Cessna 185 under STC, or in other aircraft models with a 337 that uses the Cessna 185 STC as a basis for approval.
What are the installation requirement for the TSO Lights?
If the lights are mounted to an existing mounting location with no structural modifications, and existing wiring can be re-used, the lights can be installed with a log book entry.
If there are modifications to the wiring, a 337 should be submitted for approval for the installation.
If there are structural modifications made to mount the lights, a more extensive approval may be required, ranging from a 337 to an STC.
What are the recommended wire for the Pulsar and Suntail lights?
We recommend 3 conductor 20 gauge shielded single bundle wire, which we have available in our accessories area.

Share your knowledge of this product. Be the first to write a review »